Tenax Colored Flowing
Tenax Colored Flowing is a high-quality polyester mastic used to horizontally repair, rebuild, glue, and fill marble and quartz surfaces. This will cure shiny and is very polishable. Not suitable for temperatures below 32°F. Recommended for interior use. Other colors are available upon special request.
You might also want to check the extensive line of Tenax Adhesives.
Instructions for use
Make sure the surface to be treated is dry, clean, and free of dust. If coloring, add the coloring paste to the resin before mixing it with the catalyst. An excess of coloring paste may affect the final product so use caution. The mixing ratio of resin to catalyst is 100:2 – 3 (see chart below). Stir vigorously and apply. Do not place unused products back in the can. Make sure the can is sealed tightly after use.
Technical Information for Tenax Colored Flowing
|Viscosity cps 77° 20 r.p.m.(ASTM D2196)||15000-19000 cps|
|Density at 77° gr/cm 3||1.7|
|The ratio of use glue/hardener||100+2/3|
|Gel time (in bulk) at 77° in min||3-4 min|
|Tacky free in a thin layer at 77° in min||15-20 min|
|Working time suggested at 77° in min||60-80|
|Minimum reaction temperature||32°|
|Minimum temperature of use after hardening||32°|
|Maximum temperature of use after hardening||+230°|
|Shelf life at 77°||6 months|
|Tensile Test ASTM D638|
|Ultimate tensile stress MPa||50|
|Flexion Test ASTM D790|
|Breaking Load MPa||110|
|Tensile Test ASTM D 4541|
|Adhesion force at 77° on botticino polished after 2 hours||4.0|
|Adhesion force at 77° on botticino polished after 24 hours||5.5|
Keep away from heat, humidity, and sun. The product will last at least 6 months if kept between 65°F – 77°F.
Please read the safety data sheet before using it.